Get cell value from a table

Hi all,

I have set up several tables inside autocad that have one cell as the input cell and after regen the others perform calculations based on that cell. I want to write a command that uses the same value as the input value to draw the arc to scale. I tried using the table value as is called out in the cell field: ^C^C_arc 36,6;e;0,6;r;Table(8796085192704).A3;. Is there anyway to get a value from a cell inside autocad and put it into my macro so I can draw an arc of the radius shown?

Thanks for all your help

Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.