I have imported a .dxf file of a surfboard from another program as seen below. My plan is to create various cross sections of the board in order to cut out a wooden frame. It seems like it should be simple enough but I usually use pro/engineer for any 3d stuff and I have had no luck using the section plane feature on autocad so far. Any tips would be greatly appreciated!
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Clik here to view.
