i have done a search on this and can't seem to find anything that makes sense as to the problem i am having here.
working with 2014 acad and i have made myself a partial CUI. it is really only one extra tab on the ribbon with a few of the standard panels i use in one place. nothing to out there. so here is a step by step of what i did to get this cui file.
entered comannd CUI in command prompt.
went to "Transfer" tab in the CUI dialog box
on the left panel it is "Main Customisation File (acad.cuix)"
on the right panel i created a new CUI file.
then right clicked the "Ribbons" path and created new "Josh's Tab"
then transfered the panels across i wanted
then saved the cui as "Josh's CUI.cuix"
then loaded the .cuix file via the "CUILOAD" command
at first nothing at all happened, so i unloaded and reloaded it. then closed and opened acad again. still nothing
so i loaded it and unloaded it a few times again. so i went back to "CUI" and had a look at my partial and it hadn't saved anything.
so i created a new tab again "Josh's Tab"
transfered the panels again and saved the file then loaded and reloaded the .cuix
when i loaded it acad "blinked" while it reloaded all the CUIs and my tab was there but no panels. i had another look at the CUI and the panels are there but not showing in the ribbon.
i have done this from 2009-2012/13 (can't remember which i was last using) and never had a problem. i have been away from Acad for the last 16months though so i figure i have just forgotten one simple step somewhere. I have the current SP installed also.
any help greatly appreciated. :)