Hi,
I use AutoCad 2011 and would like to sweep a bridge cross section along a road axis - a 3d polyline generated in AutoCad Civil 3d 2013 -, but I'm not satisfied with the outcome, since the profile is obviously twisted during solid generation - the inclination of generated cross sections is not correct (3.8% instead of 3.5%)... Off course I disabled the twist and bank in command parameters. Is this an error or is it normal? If anyone can help I will really apreciate it...
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Clik here to view.
