FLATSHOT

I've been asked by @AutodeskHelp on Twitter to post this in the hope that there's a solution

The attached file shows the problem.

If you rescale a block using it's properties. Then use FLATSHOT to generate a view (2D or 3D). The rescaled block reverts back to it's original dimensions

In this instance it could have resulted in a services hole being cut in the wrong place in a S/S top, but I imagine it could be a more costly mistake in different industries

Any fixes

Regards

Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.