My 2013 AutoCAD file needs to "regen" after just scrolling in and out once. I can't do anything because the lines are disconnected and jagged all of a sudden. This started a few hours ago after I drew a spiral staircase and blocked it. I noticed the lines were all of a sudden not connecting while drawing the stairs though. Is there a command that I might have accidently typed to change some type of format? or unit set up? I have been working on this file since September and this problem has never occured. The lines look fine from far away, but when you zoom in there's a clear separation. My snaps are on and they seem to be aligning when I click, but when you zoom in they're not touching at all. I've been googling for soooo long and can't find an answer. My units are 1/8" (Architectural) and when I check the dimension between the two lines it says it's 0". Pleeeeease help!!!! Thank you!!!!!!
↧