I draw a circle with radius 2', and I create a block and do the attribute definition. When I inserted the block, it turned out to be an 2 3/8" inches circle. I tried several times, but the results are the same.
Here is my step:
1. draw a 2' circle
2. create a block (attached the block definition)
3. the Block Editor is opened, command : attdef ( attached the attdef)
4. Place the elevation_tag# at the center of the circle
5. save the block
6. close block editor
7. command: insert, I inserted the elevation tag
8. I attached the inserted block, when it compares to a 2' circle, it is obviously smaller.
Is it possible to tell me the steps that I am missing? Thank you