It might seem obvouis to most but i can not get my contours in the corridor to recognize the curb line or the centerline of the road. Assembly is shown below a snap shot of the section view.
Curb on both sides, sidewalk only on one side. I have a crowned road section with 2% slopes and I used the basic curb & Gutter sub-assembly with a 7" reveal. This has never happened before and I hope it is a simple solution. Anyone encounter this?
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Clik here to view.
