I need to insert three points into a drawing using their latitude and longitude values. I'm not sure how to do this directly, but I feel that the easiest way may be to use the coordinate system to the bottom left of the screen (set to Geographic... and I already have my coordinate system set up to the NC Grid). However, the coordinate system when using the "Geographic" setting only shows two places past the decimal point.
Is there some way to have the coordinate display system show more places after the decimal, or is there an easy way to create a point using latitude and longitude? I read one post that recommended using an "LL" command, but that isn't working for me (I'm sure I'm doing something wrong). Any help would be greatly appreciated!!
Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Clik here to view.
