Drawing Breakout

AC 2015, Win 7 64

Hi all.

I'm wondering if someone out there can help me increase my productivity with some quick code or custom commands.

I'm not that familiar with diesel, macro's or lisp (Yet), so I'll try anything right now.

Here's the problem:

I'm doing multiple drawings (100+ so far), each with 10-20 layouts. Once the dwg is approved, the dwg must be broken out into individual files, with one dwg and it's associated layout in each file. (Example attached)

File names are like this (always similar) ABCD-EF-GHIJK-11-222-3333-001. The last 3 numbers are all that change, and they are sequential.

(Note, it doesn't matter if each file has everything after breakout, since I have to PDF them individually anyway (see request #2 below) , so I have to go back into them and delete a lot of stuff),(although it would be great if only the appropriate layout remained in each broken out file).

If it helps, I give my Tab Names the same as the last 3 numbers of the sheet, which is also the last 3 digits of the file name (ie. 001, 002, etc).

Prior to the actual breakout, I'd like to run:

1. Purge All (twice) (since one time doesn't usually do it)

2. Zoom Extents all Layout(s)

3. Save All

4. Create new files (in a location I specify. They all go into the same folder)

As for my second (separate) command, I'd like to be able to (from Model Space), (which I would run on each of the broken out files):

I will open a file, delete all the unnecessary stuff and then run:

1. Change to and Zoom Extents Layout(s)

2. Purge All (twice)

3. Save All

4. Batch Plot

From here, I take control and select the file locations, etc.

I know it sounds like a lot to ask, but any help is greatly appreciated.

Thank you all.

Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.