Autodesk Vehicle Tracking installation

Hi, I am running Factory Design Suite 2014 Stand Alone version, and I have downloaded and sucsessfully (I think) installed Autodesk Vehicle Tracking 2015 from my reseller. I put in all the correct licence keys and seriel numbers etc. However when I run autocad the vehicle tracking is not in the ribbon. I have browsed these forums for similar problems and found this - 

http://forums.autodesk.com/t5/AutoCAD-Civil-3D-General/How-to-open-vehicle-tracking-add-on/m-p/4967340/highlight/true#M246794

This thread mentions to do this

1. Enter CUILOAD in the command line and browse to the following location:
2. C:\Users\<users>\AppData\Roaming\Autodesk\Vehicle Tracking\Menus
3. Select atrc200.cuix and click Open
4. Click Load and Close

But when I get toC:\\Users\<users>\AppData\Roaming\Autodesk\ There is no Vehicle Tracking folder. I have also searched for a .cuix file but cannot locate one, is this because it's for 3D Civils?

Another method I tried was to run APPLOAD within Autocad. I navigated to C:\Program Files\Autodesk\Autodesk Vehicle Tracking 2015\atra200_arx but when I attept to load this I get the error message "Unabled to load atra200_arx.arx file."

The third method I have attempted is to navigate to C:\Autodesk\WI\Autodesk Vehicle Tracking 2015\x64\AVT_CMD_REG\Autodesk Vehicle Tracking 2015_64.exe to run the setup, however I get the message "Setup was unable to detect any target applications for Autodesk Vehicle Tracking2015"

I've exhausted all my knowledge on the subject, could anyone help?