In the attached model i would like to offset all the arcs in one direction by 20mm (i will convert the splines into arcs before i do this). The radius of each arc would therefore need to increase by 20mm (keeping the same centre point), and the angle of the arc would need to stay the same.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Clik here to view.
