Hello,
I hope this is the right section. Im looking into creating a macro/routine/'something' that will enable me to draw a handrail plan, based on a series of prompted dimensions.
Essentially, i want to draw a series of circles and squares on a line, the spacings of which is determined by a few (around 6) dimensions, that are manually entered in a prompted box. Usually the pattern is [circle, 3x squares, circle] however i may want to repeat this more then once with a spacing between them. The attached pdf should explain a bit better.
I think what i am after is reletively simple. Ideally, i would like to know how to do it, so that i can edit/ammend it as necessary.
Any help is much appreciated.