Hello everyone,
I have just made an Hatch ANSI32 on my drawing. This has a set of 2 lines each, but I would like to have 4 lines set. Is this possible? If so, how that could done? (See the Picture below). Thank you for your kind help.
Seiji
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Clik here to view.
