Hello to everyone,
Is there a way to make a dynamic block where I will insert the total length of this “ panel”. Say 3720mm, and that it will divide the “panel” into equal segments with a maximum segment width of 1240mm. ( so with 3720mm that would make 3x 1240mm segments)
Say it would be a “panel” of 5500mm it would be 5 segments of 1100mm, and a “panel” of lets say 3750mm would make 4 segments of 937,5mm.
I made a drawing to illustrate what I meen,
Hopefully you guys can help me out,
A dynamic block for this will save a lot of time!
All help would be greatly appreciated.
Kind regards
(here is the example)
