Hello all...
Take a look at the attached block. The purpose of the block is to designate match points between floors of a building. The idea is, on the floorplan you have an "A" at the top of the bubble, and then on the inset you have an "A" at the bottom of the bubble, so "A-A" matches when combined.
However, when I went to put the attribute in the block, it stops working. What's weird is, when you're in the block editor, and you go to "test block", it works fine... but if you exit the block editor, the attribute disappears, and when you double click on the block to edit the attribute, the block editor comes up, as if the attribute isn't there.
Lastly, does anyone know of a way to edit both letters with a single edit? In other words, the user places the block in the drawing, double clicks it and the edit attribute comes up... they change the "A" to a "B" and it changes both the top and the bottom "A" to the B so that there's not two attributes they have to change (because they'll always match).
I hope that makes sense... any help would be GREATLY appreciated!!!
EDIT: Oh, and I tried ATTSYNC and that didn't seem to work. When I did it, it says "there are no editble attributes in this block", but it says the text is an attribute when you're in block editor.