A colleague using a dynamic block we have for steel sections is having a problem, we have a text attribute which reads off a lookup table and displays the selecetd beam size.
For some reason the result ends up as ####, even though the block geometry is properly set up.
When I do an edit on the field the dialogue that pops up is: "the object referenced by the field is not a valid object".
Any clue as to why it isn't working?
I can manually reset the field for each block, but we have '00's of blocks and its rather time consuming.
DWG attached shows a block which isn't working next to one that is, showing the definition is at least fine.
I've tried ATTSYNC and RESETBLOCK and no effect. From previous discussions on this, SAVEFIDELITY is off and not using annotative scaling. The failing block was also inserted into the attached file, so it isn't down to the block definition, its something to do with how the object information is extracted by the field?
Thanks.
Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Image may be NSFW.Clik here to view.
Clik here to view.
