Ribbon minimize state not remembering selction.

Hellol.  I found a similar question about toggling ribbonclose and ribbon but that did not answer my question. I'm using AutoCAD 2014 and there is a setting to either toggle through all ribbon states or you can select one.  You can cycle through:

Minimize to Tabs

Minimize to Panel Tiles

Minimize to Panel Buttons or

Cycle Through All

I want it to always minimze to tabs but when I close CAD and re-open it doesn't remember that selection and always cycles through all minimized states again.

I don't see any system variable or registry value that seems to save this.  Anyone know how I can make it remember?

Thanks.

Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.